Generating set parameter displays (2 X 4 line LCD display)
AC voltage phase to phase and phase to neutral
(on 3 phases)
AC current (on each of 3 phases)
Frequency
CosF (power factor) average
kW - total + per phase
kVAr - total + per phase
kWh - total
% Voltage difference between bus and generator
Phase shift
Frequency slip
Hours run
Coolant temperature
Lube oil pressure
DC voltage
Bus parameter displays
AC voltage (on a single phase)
AC voltage/frequency within limits indicator
Operator controls
Off/auto/test/run control switch
Emergency stop pushbutton (lockdown)
Membrane keypad with tactile feedback
AC voltage adjust - manual and automatic
Engine speed adjust - manual and automatic
System controls
3 attempt start counter
Cool down delay
Pre-glow delay
Remote start capability
Check synch relay
Reverse power relay
Manual synchronizing
Automatic synchronizing
Automatic load sharing control
Automatic loading and unloading ramp controller
Automatic mains failure controller
Load sequencing control
Static battery charger (5amp) 220/240 Volt AC
Quadrature droop kit
Shutdowns and alarms
High coolant temperature shutdown
Low oil pressure shutdown
Overspeed shutdown
Fail to start shutdown
Emergency stop operated
Reverse power shutdown
Overvoltage shutdown
Undervoltage shutdown or alarm
Overfrequency shutdown
Underfrequency shutdown or alarm
Alternator loss of excitation alarm
Fail to synchronize alarm
Battery overvoltage shutdown or alarm
Battery undervoltage alarm
Bus overvoltage alarm
Bus undervoltage alarm
Bus underfrequency alarm
Bus overfrequency alarm
Bus load surge
Spare fault channels, up to 3:
– Low coolant temperature alarm
– Low fuel level shutdown or alarm
– Low coolant level shutdown
Status indicators
Load switch status indicator
General switch status indicator
Fault log memory
Password security
Interface to remote monitoring package